SOHC.co.uk Forums > Project Board

The rebirth of Lazarus

<< < (50/86) > >>

mickwinf:
Ken I have adjusted the outer slot as per manual, then taken up the cable slack with the cable adjuster. At first it seems OK but seems to lock in the clutch disengaged position even if I release play on the cable. Clutch basket was shimmed.

Trigger:
Do you have the clutch cover off to see what is going on Mick. I have never come across this before  ;)

Oddjob:
Take the cover off Mick and take a picture of the insides, see if we can spot what the problem.

Oddjob:
Did you fit the ball bearing inside the spiral drive? Been wracking my brains what this could be and with no ball bearing it could be the spiral drive hangs out of the housing when the clutch is pulled and it’s this which is jamming it open.

mickwinf:
Well i have found the problm, it turned out to be the new cable of all things. The plastic liner was damaged and was not allowing the clutch mech to release and I didn't spot it as it was hidden under the rubber boot inside the cover. Will order a new one and keep plodding on. Thanks for the advice guys.oh what route should cable take is pic correct?

Navigation

[0] Message Index

[#] Next page

[*] Previous page