SOHC.co.uk Forums > Project Board
The rebirth of Lazarus
Trigger:
--- Quote from: mickwinf on September 10, 2023, 05:46:54 PM ---managed to put on youtube
https://www.youtube.com/watch?v=sOScVJ4W2fs
--- End quote ---
Little advise Mick, take a tappet cover of number 1 as well, to see you have oil on both sides.
Sounds like a sweet running engine.
mickwinf:
have been working on the carbs, all ok internally but doing a cosmetic externally. I have removed the operating rod, and is in very good condition unlike most. I need to sort the pin that stops the movement side to side and was thinking a suitable screw but only seems about 2mm. What do you guys use?
McCabe-Thiele (Ted):
Ken told me he taps a thread in the hole then reduces a screw to suit.
I have an old carb air screw that might do the trick on mine - not sure of the thread.
Depending on how big the drill out is M4 looks about right on mine.
mickwinf:
Carb air screw is a possibility but maybe a bit big.
McCabe-Thiele (Ted):
Cut down to suit?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version