SOHC.co.uk Forums > Project Board
The rebirth of Lazarus
Bryanj:
Tank, have you got an old school radiator repair shop local, they may be able to solder patch(s) on.
Clutch the mechanism can be very finicky as is the adjustment, the was a bulletin on adjustement, shoul be in ashs dropbox, cable routing is vital, pdi and build list should also be in dropbox.
This sort of problem is one that is probably an easy fix in person but impossible at distance!
mickwinf:
Hi Bryan, did think about the radiator place, will make enquiries. I thought I would do a couple of easy jobs today but not working out that way! back into the garage I go!
Oddjob:
Ball bearing in the clutch adjuster Mick?
mickwinf:
yes Ken I got a new one to make sure. I seem to have sorted it, i turned the main adjuster fully in and left it in that position instead of backing it off as per manual. Also the threaded adjuster at handlebar end was a little tight and was snagging on the nylon inner cable so filed that down, still think the plain cables are better. Had to walk away as getting frustrated today, I will return to battle tomorrow!
mickwinf:
not much happening as I have been ill for a couple of weeks, but still struggling with the front brake bleeding. all new or refurbished, hoses rubber seals etc but just will not bleed. I have tried all the usual methods with syringes but no luck so getting really frustrated, even dismantled master cylinder in case i did something wrong.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version