SOHC.co.uk Forums > CB500/550

Alternator cable grommet.

<< < (3/4) > >>

AshimotoK0:
I would cast it with 2-part polyurethane.

That's what RGP750 on here uses to make rubber parts.

Sesman:
Thanks….project.

Bryanj:
The black sticky stuff is Sicaflex 221 but you must get black as aparently the grey does not go hard

Laverdaroo:
Just a thought but have a look at INNOTEC pond sealant. I use it to secure butyl patches for underwater fixes on welded seams in pond and lake liners. They also use it for car under body flexible sealant. If you can form a mould  to push it into it sets like a tough inner tube type, mastic with a matt appearance. It comes in black grey and white.

The easiest place to get a tiny syringe type thingy is from the aquarium shop, they do it in a repair kit tube of about 300cc's,  bit like teh size of a large arraldite two part mixing syringe It comes in a mastic tube as well but they're about £25 a pop. From the aquatic shop it'll be about 4 or 5 quid.


I'll try to find a link and bob it up in a bit after me tea.....

Laverdaroo:
Found it, Ebay number.....190791780450

Navigation

[0] Message Index

[#] Next page

[*] Previous page