SOHC.co.uk Forums > CB350/400

alternator wires covering

<< < (3/3)

Deano400:
If you need any white I've used this in the past.

https://www.ebay.co.uk/itm/401348381710?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649

philward:

--- Quote from: Deano400 on November 13, 2021, 11:14:24 AM ---If you need any white I've used this in the past.

https://www.ebay.co.uk/itm/401348381710?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649

--- End quote ---

What size did you use Deano?

Deano400:
Hi Phil.
Can't remember what I bought but measuring what I have in the garage it appears to be 6mm and 8mm dia. I used it on a 400/4, the 6mm for the two wires from the points and the 8mm for the 3 wires on the alternator side. I used a bit of tape on the ends to secure the the sleeving and than covered the tape with black heat shrink to finish it off.

ST1100:

--- Quote from: Deano400 on November 13, 2021, 11:14:24 AM ---If you need any white I've used this in the past.
https://www.ebay.co.uk/itm/401348381710?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649
--- End quote ---
Valuable tip, bookmarked...  8)

Navigation

[0] Message Index

[*] Previous page