SOHC.co.uk Forums > CB500/550
550 F2 started!
Laverdaroo:
--- Quote from: Nurse Julie on November 14, 2021, 09:05:21 AM ---Roo.... Trig has a box of used carb jet springs here that he's just told me about 🙄🙄🙄.
Edit...... I've found 2 in the box that are usable Roo.
Edit...... Found another 2 as well.
--- End quote ---
ooo, ooo, BAGSEY!!!!! 8)
Nurse Julie:
--- Quote from: Laverdaroo on November 14, 2021, 11:57:43 AM ---
--- Quote from: Nurse Julie on November 14, 2021, 09:05:21 AM ---Roo.... Trig has a box of used carb jet springs here that he's just told me about 🙄🙄🙄.
Edit...... I've found 2 in the box that are usable Roo.
Edit...... Found another 2 as well.
--- End quote ---
ooo, ooo, BAGSEY!!!!! 8)
--- End quote ---
OK Roo, see what else you need that we may have or you'll be spending more on post than parts 🤣🤣🤣🤣
Laverdaroo:
[/quote]
OK Roo, see what else you need that we may have or you'll be spending more on post than parts 🤣🤣🤣🤣
[/quote]
ha ha, I will. I only set about it as it was that or start painting windows............BOL++CKS to that thought I, I must have something to fiddle with in the shed and Mejima was the first thing I saw so before I knew it the carbs were being split on thekitchen table 8)
Chewy is getting moved to the hall for the winter so I can fiddle with Rosey, (the VFR) and the 550 so it appears that its going to be a busy winter ;D
As soon as get the frame replacement (up in Wakefield still) I can start sticking bits on it and see what else I need. I'l keep you posted Julie ;D ;D ;D
I knw youre a Gin fiend, whats Trig's tipple?
Laverdaroo:
--- Quote from: Oddjob on November 14, 2021, 02:13:31 AM ---Looks like someone has already removed the pin, the surface is far too flat for the original finish.
Also the butterfly looks out of line with the cable clamps.
--- End quote ---
The whole thing is out of jig a bit, it appears its had a hard life but Im sure it will nanny up ok. Is that the pin then, I cant see any way of getting the bar out as it rocks slightly to either side but theres nothing else physically there that could effect the removal. If it is, what do I replace it with?
I thought that a shaft from a used rivet might be good as its fairly soft and can be filed soon to suit once in? What does the consensus use when tackling this issue. The bar has to come out its well hammered and needs sorting, its not going back on like it is.
Bryanj:
You tap the hole and make a bolt with a pin end to fit in the groove of the shaft that you will see when its out
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version