SOHC.co.uk Forums > CB500/550
550 F2 started!
Laverdaroo:
I might bob up to the garage and see if I can use the press Ken, Ive new circlips on order too so no dramas on that one, my mate saidit was a no brainer so ordered them last night.
Cheers, mate.
Oddjob:
A press would be fine Roo, again I'd protect the ends of the shaft, just in case.
Just found the setring and the oil control vales.
Also just found the dowels which hold the needle rollers in place, they are 6mm wide and 10.4mm long. That match what you were looking at?
Laverdaroo:
jjust got in burt off to the cave of dreams a bit laterm Ill have look and get bck to you mate.
Nice one Ken ;)
SteveD CB500K0:
--- Quote from: Laverdaroo on August 24, 2022, 06:09:50 PM ---off to the cave of dreams
--- End quote ---
Too much information
Sent from my iPhone using Tapatalk
Laverdaroo:
--- Quote from: SteveD CB500K0 on August 24, 2022, 06:53:27 PM ---
--- Quote from: Laverdaroo on August 24, 2022, 06:09:50 PM ---off to the cave of dreams
--- End quote ---
Too much information
Sent from my iPhone using Tapatalk
--- End quote ---
Not THAT cave Steve, that's Thursday nights! ;D :o
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version