SOHC.co.uk Forums > CB500/550
550 F2 started!
Oddjob:
No Roo, the end caps that hold the spindle will still be silver like the old finish on the sliders.
That would look odd.
Luckily I thought about it and polished 2 end caps today.
Just doing a few bits on the slider, areas the mop won't reach. Coming along nicely.
I'll need to dig the other slider out and make sure I did the final touches to that or they'll look odd.
Laverdaroo:
Doh, of course.
They're going to be epic Ken, and you said they werent good enough for yours!!! Cant bloody wait to see your creation. That is if you stop spending all your time doing things for other folk, you might get a chance to do some of your own mate. Bless yer :D ;) :)
Oddjob:
Finished.
Done both the slider and the 2 fork caps, just need to check the other slider now. That's hiding in the loft.
Laverdaroo:
speachless mate, thankyou. :)
Oddjob:
The arrows are still on them, so you know the orientation. Mine have been buffed off as if you ever need to know you can just put them on a flat surface, press down and the rear will always rise up as it's not as deep as the front.
Pic not a great one TBH, took it indoors as it was dark by the time I'd finished. They look much better in natural light.
I've got some stainless studs, washers and nuts for mine along with a stainless drain bolt and of course those stainless seal circlips. New dust seals as well and newly hard chromed fork stanchions. Brand new stainless top nuts as well. Should look pretty good I reckon.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version