SOHC.co.uk Forums > CB350/400

Cross drilled discs

<< < (2/9) > >>

Laverdaroo:
Nicely done sir, terribly satisfying isn't it ;D 8)

allankelly1:
Yes very nice especially on a spoked wheel.

but my own work as found pic on web but love the design so thinking by of copying onto my front and back disc set up


Sent from my iPhone using Tapatalk

Laverdaroo:
I did mine on the kitchen table, the hardest part of the whole process was not getting toast crumbs under the paper

Loads has been written on the amount of drill bits people get through but I had absolutely no issue at all.

My pedestal drill is with the large in the container so had to improvise but worked a treat.

I calculated the curb as being exactly a 4” masking tape reel with 1/4” of tape still on it

Worked pretty good and looks ace. I’ll be doing the 550 the same when I get that far forward, just started the carbs




Sent from my iPhone using Tapatalk

Laverdaroo:



Sent from my iPhone using Tapatalk

allankelly1:
Nice

Once I have sorted my back out I have a nice dividing head at work so should be a simple operation once I have worked out pitch and pattern


Sent from my iPhone using Tapatalk

Navigation

[0] Message Index

[#] Next page

[*] Previous page