SOHC.co.uk Forums > CB500/550
Honda CB500 Four tool tray .
Seabeowner:
--- Quote from: deltarider on December 13, 2021, 11:38:18 AM ---Don't know if you have interest in copying it in detail, but know that 83501-323-020 originally had a small 'enclave' to accomodate spare fuses.
--- End quote ---
And of course the separate bit that holds the mesh over the oval cutout will also add to the work. 83502-323-000
The tray looks awkward to print as there are bits above and below the tray. Presume it will need support pieces. Took a look at it here and decided against it.
Oddjob:
Someone was already printing those Seabeowner, can't remember who now though.
Laverdaroo:
--- Quote from: AshimotoK0 on December 13, 2021, 06:40:34 PM ---
--- Quote from: Laverdaroo on December 13, 2021, 04:41:40 PM ---I possibly might although Im not sure until crimbo when I've the heap on the ramp and start to take it to bits. What sort of money will you be asking for one or are you not too sure yet?
--- End quote ---
Is that for your F model ...I don't think the F's had that part.
--- End quote ---
Pf course, disreguard that last coment then ;D ;D ;D
Blonde moment :o
AshimotoK0:
--- Quote from: Oddjob on December 13, 2021, 07:24:02 PM ---Someone was already printing those Seabeowner, can't remember who now though.
--- End quote ---
I think Richard on here (RGP750) was casting them Ken not printing .. could be wrong though :-[
BenPowell:
--- Quote from: Seabeowner on December 13, 2021, 06:54:36 PM ---
--- Quote from: deltarider on December 13, 2021, 11:38:18 AM ---Don't know if you have interest in copying it in detail, but know that 83501-323-020 originally had a small 'enclave' to accomodate spare fuses.
--- End quote ---
And of course the separate bit that holds the mesh over the oval cutout will also add to the work. 83502-323-000
The tray looks awkward to print as there are bits above and below the tray. Presume it will need support pieces. Took a look at it here and decided against it.
--- End quote ---
It will be a bit tricky without a doubt and certainly will need some support material, having said that I’ve done some awkward stuff for work so I’m willing to have a go at it. I have the separate part which holds the mesh on but will finalise it once I’ve got a tray printed, so I can make sure it is a good fit.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version