SOHC.co.uk Forums > CB500/550

Head bearing dust seal

<< < (2/2)

andy120t:
Thanks for the replies. My concern is now about the  washer as much as the dust seal - is there a reason for having this ie to seat the bearings on.

The bearing kit I have only has the bearings in and they are "open" so am happy to apply stacks of grease to them. Just interested in the use of the washer. Might buy one anyway and measure it all up carefully before fitting....and finding out I have to take the bearings off again!

andy_c101:
As I said, I didnt use any washer & my steering head bearings are ust fine.

Yoshi823:
Ok...I have finally managed to locate the dust seal that I had mentioned previously.

The ID is 30mm
The OD is 56mm
The thickness of the metal part of the seal is 0.5mm
There's a rubber lip around the outside edge.

The Honda part number is 53214-371-010.

Navigation

[0] Message Index

[*] Previous page