SOHC.co.uk Forums > CB350/400
The elusive surge
Alexrayz:
Hey Alan,
That would be great indeed, I'll see that with you by PM! I was thinking of making a sudo retainer with a wire coathanger, just something to hold the filter snug.
allankelly1:
--- Quote from: Alexrayz on January 19, 2022, 12:05:18 PM ---Hey Alan,
That would be great indeed, I'll see that with you by PM! I was thinking of making a sudo retainer with a wire coathanger, just something to hold the filter snug.
--- End quote ---
Yes coat hanger would work
Also modelled your air box lid now
Sent from my iPhone using Tapatalk
Alexrayz:
Thanks Alan!
allankelly1:
--- Quote from: Bryanj on January 19, 2022, 10:51:19 AM ---If you have covered the top with tape no air can get in! Use half a clothes peg to pushthe filter forward and leave the top open totest
--- End quote ---
Solid lid or duct tape is ok as there snorkel at the back of the filter housing
Sent from my iPhone using Tapatalk
Alexrayz:
--- Quote from: taysidedragon on January 19, 2022, 11:48:59 AM ---Alex, the best way to get the airbox rubbers to fit onto the centre carbs is to remove the air filter element from the air filter box, remove the connector tube and rubber to give you as much access room as possible.
Then use a screwdriver handle or a piece of wood with a rounded end to push the airbox rubbers forward onto the carb stubs from inside. Your hand has to manoeuvre down into the air filter box and partly through the large opening in the front.
It's difficult, frustrating and even painful at times, but it's possible.
--- End quote ---
I shall suffer then. Sucks to have big hands in those cases. Thanks for the tips!
Gotta say this thread is starting to co;pile quite a bit of info, good for everyone.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version