SOHC.co.uk Forums > CB350/400
Clutch switch circuit not working question?
SteveW:
All the diode does is prevent the neutral light coming on when you pull the clutch lever in.
Deano400:
--- Quote from: BigAl (Alan) on March 08, 2022, 07:35:30 PM ---Not wishing to change the thread...it is related to the diode assembly, was there a part number for the rubber boot that supports the 2-way connector and diode? as image Handy item, as it also has a slot to clip onto the bike frame.
--- End quote ---
Part number for the rubber is 32135-124-300
BigAl (Alan):
Many thanks, cmsnl have some in stock!
McCabe-Thiele (Ted):
--- Quote from: Bryanj on March 08, 2022, 08:12:32 PM ---Wherever you fit that green earth terminal dont forget to remove the new paint/powdercoat so it touches frame metal
--- End quote ---
Absolutely, seems strange that the only loom earth is fastened to the regulator bolt that is rubber bush mounted like the whole air box frame - does not strike me as the best place for a good earth connection. I might fasten an extra earth cable on top of the existing one then bolt that to somewhere out of sight where I can remove the powder coating to be sure of a good earth connection.
tbh I was wondering if I ought to do that where the rectifier is bolted to the frame - the wiring diagram shows a green earth connected to the unit plus the three yellow wires and the red one. This looks as though it is just internally earthed so maybe no need to.
Navigation
[0] Message Index
[*] Previous page
Go to full version