SOHC.co.uk Forums > CB500/550

Carburettor wrench tool

(1/3) > >>

Erny:
I'm considering to make this tool, as I'm quite bothered using normal 8mm socket and screwdriver for carb sync. Each time I tighten nut it moves screw a bit and sync is not accurate...

Found this original Honda tool, want to make something similar https://www.cmsnl.com/products/wrench-carburetor_079083230200/

If somebody has it, can you pls measure key dimensions for me?
Dimensions I'm looking for see attached picture

Oddjob:
I have the longer and IMO the better version.

Sometimes the carb sync screw is quite deep down inside some carbs where that one would struggle to reach or the frame would get in the way.

I'll post a pic of it with dimensions if your interested Erny.

Erny:
Sure, I am!

Trigger:
The tool in the link is too short for SOHC carbs and why would you want to make one when they are cheap to buy >>> https://www.ebay.co.uk/itm/352431313684?hash=item520e8b1314:g:kT4AAOSwLSZb~mov

Sesman:
Agree. That’s the one I use. It’s very effective, but not perfect and needs technique.

Navigation

[0] Message Index

[#] Next page