SOHC.co.uk Forums > CB350/400

400 wiring loom route question?

(1/4) > >>

McCabe-Thiele (Ted):
When I purchased my 400 the wiring loom was not really fitted as such - more thrown into place.

Yesterday when I came to tidy up the area to the front left side of the petrol tank area where loom meets handlebar switch cables the mini wiring strap was all sort of wrong so I am not happy with the loom route as it is.

I looked at some schematic loom diagrams I had downloaded from the internet.  I noticed that in the diagrams it shows the main loom where it passes under the petrol tank going over the top of the left side coil - presumably to keep away from engine heat?

Can anyone confirm that this is the correct route please before I hitch the loom above the LHS coil ?

Lastly at the rear does the rear brake light switch connect to the loom by crossing the back of the rear mudguard where it connects into the loom?
Again some photos show the rear brake light switch connecting on the right hand side of the bike with the loom split forking onto the RHS cover area?

paul G:
Hope this helps

McCabe-Thiele (Ted):

--- Quote from: paul G on March 23, 2022, 12:11:04 PM ---Hope this helps

--- End quote ---

Thanks Paul If that is the correct 400 route then a small change will take place during the warm spell to move it above the coil. I was not sure I had the right model diagram.

Any idea about the brake light switch wiring route Paul I might have to tweak a bit more near the fuse box area?

paul G:
This one

paul G:
Might as well post these as well

Navigation

[0] Message Index

[#] Next page