SOHC.co.uk Forums > CB750
STARTER MOTOR GEAR WASHER
mortyboy:
--- Quote from: Bryanj on April 17, 2022, 05:53:38 PM ---Its an odd size and hardened from memory
[/thankyou Bryan
--- End quote ---
mortyboy:
--- Quote from: philward on April 17, 2022, 09:39:51 PM ---I was short of this washer but a member had a spare one but spotted this on ebay that includes the washer - expensive for a washer but better than none! The 'shim' is hardened - I can provide sizes if you want but before I got one, I struggled to find anything generically that was similar
https://www.ebay.co.uk/itm/35385581182
Brilliant, thankyou!
--- End quote ---
mortyboy:
--- Quote from: philward on April 18, 2022, 04:26:06 PM ---Here you go - OD 39.88mm - ID 12.25mm - 1mm thick
That's great and really helpful. Thankyou very much. I have a new lathe & mill arriving soon so will try to run one up - along with a few other parts!
--- End quote ---
AshimotoK0:
--- Quote from: mortyboy on April 20, 2022, 11:11:35 AM ---
--- Quote from: philward on April 18, 2022, 04:26:06 PM ---Here you go - OD 39.88mm - ID 12.25mm - 1mm thick
That's great and really helpful. Thankyou very much. I have a new lathe & mill arriving soon so will try to run one up - along with a few other parts!
--- End quote ---
Problem is it's more of a hardened shim than a washer ... there are loads of places who do custom hardened washer/ shims in the UK. I had some made for my CB500/4 valves.
--- End quote ---
paul G:
If it's the same as the K1 i have one somewhere.
I could not find mine in the pile of bits that came with the bike, but you guessed it I managed to get hold of one and then found it.
I will have a look tonight.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version