SOHC.co.uk Forums > Project Board

400/4 build. Paused due to other commitments. But starting up again

<< < (24/94) > >>

Nurse Julie:

--- Quote from: ComfySofa on November 04, 2022, 08:01:27 PM ---OOh - just remembered (another question) is there a way of bonding an earth cable between the engine and frame...or is there another way of doing it...? (i was going to lift the engine and sand some of the powder coating away so where the engine connects to the frame (so its earthed where the bolts go through)

Cheers

--- End quote ---
There are quite a few earthing points on the frame / bike but you just need to remove the powder coat so the bolt and washer hits 100%  metal and not powder.

ComfySofa:
Right...so sanding a bit away on each of the engine mounts is the best way....less wires is a good thing!

Thanks very much.

Sesman:
Nope, just the important ones. Somebody else will advise which ones

ComfySofa:
Ah - ok - ill wait for that bit of info...cheers..

Sesman:
Good candidate’s are ithe rear. right upper engine mount and the upper left HT coil mount.

Navigation

[0] Message Index

[#] Next page

[*] Previous page