SOHC.co.uk Forums > Project Board

400/4 build. Paused due to other commitments. But starting up again

<< < (44/94) > >>

ComfySofa:
Came to a final point for the munit mount... As I'm using the original air box the relay can sit in its usual place...


Sent from my SM-G988B using Tapatalk

Nurse Julie:

--- Quote from: ComfySofa on January 15, 2023, 01:43:57 PM ---In the garage pottering.... As its a few years since this came apart and I'm replacing the whole loom... Wots dis then.?

Sent from my SM-G988B using Tapatalk

--- End quote ---
It's the fuse box, open it up and there will be 3 active fuses and 2 spares.

Laverdaroo:
But you won’t need it for the M unit as it has integral protection inside. Ideally you need to mount it to something metal as it earths through the mounting points so if it being mounted to a plastic box say, the system won’t work.


Sent from my iPhone using Tapatalk

ComfySofa:
I was just about to say.....(dont need that then!!)

ComfySofa:

--- Quote from: Laverdaroo on January 15, 2023, 02:20:03 PM ---But you won’t need it for the M unit as it has integral protection inside. Ideally you need to mount it to something metal as it earths through the mounting points so if it being mounted to a plastic box say, the system won’t work.


Sent from my iPhone using Tapatalk

--- End quote ---

Yep - my theory was to connect a ground from the engine/frame to the munit? (is that not good enough?)

Navigation

[0] Message Index

[#] Next page

[*] Previous page