SOHC.co.uk Forums > Project Board
400/4 build. Paused due to other commitments. But starting up again
ComfySofa:
Current state of the wiring....not too bad!
Sent from my SM-G988B using Tapatalk
McCabe-Thiele (Ted):
--- Quote from: ComfySofa on July 31, 2023, 08:53:46 AM ---Went to the site last night...shit - theyve got everything on there havent they! (it looks like theyve even got those tiny little dummy lights in LED's as well) - so assuming they fit ill definately be getting some of those...!
--- End quote ---
I fitted all LED bulbs on the instruments & panel lights. Choose the colours carefully and you get some great results. I had advice from a member but can't remember who. Green is good for Speedo & Rev counter.
Matt_Harrington:
I also fitted LED bulbs to the instruments (low profile ones to match the old bulbs) BUT found them too directional / bright. Two coats of white nail polish on the top diffuses the light perfectly. (alas the Mrs didn't have any but the pound shop did!!)
ComfySofa:
I totally forgot to take pics this morning (in the office now) do you have links to the bulbs you ordered?
taysidedragon:
--- Quote from: ComfySofa on July 31, 2023, 09:14:17 AM ---Current state of the wiring....not too bad!
Sent from my SM-G988B using Tapatalk
--- End quote ---
Getting there. I assume that the fat red lead coming out of the hole in the frame and down to the solenoid is temporary? Where it routes at the moment is where the rear tank rubber sits so it will get in the way of the tank fixing. It's normally a lot shorter and goes almost direct from starter motor to solenoid. If it is temporary, ignore everything wot I said!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version