SOHC.co.uk Forums > Project Board
400/4 build. Paused due to other commitments. But starting up again
Sesman:
Ain’t that a pressure switch on the caliper….never seen that before. It’s normally located at the headstock union.
ComfySofa:
Ah - yes - sorry....yeah - it doesnt fit on the front brake...not enough room....thought id locate it down the other end! Not ideal as the cable will be running back up the brake line....but ill see what happens...this wont be a one time build...its going to go through a bit of fettling and constant adjustment...!
Im planning to go the motogadget route....does anyone know where i can get the bullet connectors so i can crimp wires to go on all the exisiting switchgear etc etc...?
Oddjob:
Another alternative would be to use a master cylinder off another Honda, like the later GL1000 which has the brake switch on the master cylinder.
Matt_Harrington:
You won't go far wrong using these guys for connectors etc
https://kojaycat.co.uk/epages/950000457.sf/en_GB/?ObjectPath=/Shops/950000457/Categories
I tend to crimp and solder....
Matt
ComfySofa:
Thanks. Ive been here/there before for connectors for my Hypermotard. I have noticed that theres subtle differences between the diameter's of various bullet connectors....it'd be nice to match them up as i really dont want to cut any bullet connectors off of whats actually on the bike at the moment...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version