SOHC.co.uk Forums > Project Board
400/4 build. Paused due to other commitments. But starting up again
taysidedragon:
--- Quote from: Laverdaroo on August 20, 2023, 09:41:10 PM ---Nice one mate, top skills and perseverance. Is there any meat in that yellow wire to take it under the central spar and away from anything bring in it or rubbing it? That’s all I can see from those shots. Top job buddy
Enjoy Welsh Wales mate
Sent from my iPhone using Tapatalk
--- End quote ---
The standard wiring has sections routed over the frame tube as shown in the Honda wiring routing diagrams.
There's a reasonable amount of room between the frame and the tank. 👍
ComfySofa:
Cheers sir....i did check and theres not enough to run it underneath....doesnt matter though....
Onto the final straight.....
At this point im not sure where to start or what to do...you tube links would be good!! ( i am looking at the moment...) so where im currently at..
1. All electrics now finished...starter motor turns over...
2. Electronic ignition fitted (led light comes on) but not set up. (nto sure if i need anything special to set that up though)
3. Carbs not setup (and not sure where to start on that either) but i do have vacuum guages here.
All of the above does seem like you need a bit of experience or "the feel" for setting it up so not sure if ive got that yet! :)
Laverdaroo:
Sent you a couple of links so you can do it on your own bud. First ones ace second one is a bit simpler but still good and works well.
Sent from my death bed, I can see the vultures circling and it’s all going dark etc……….enjoy
.
Sent from my iPhone using Tapatalk
Oddjob:
You're too ugly to die Roo.
I'm at serious risk though. ;D ;D
Laverdaroo:
Seriously, If that’s the case you’re way above me on the list mate, don’t you kid yerself bud
Sent from my iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version