SOHC.co.uk Forums > Project Board

400/4 build. Paused due to other commitments. But starting up again

<< < (11/94) > >>

Sesman:
Yes, I’m using the pressure switch at the down pipe union. Pardon my ignorance, but what’s the bolt for under the lever pivot?

Oddjob:
The earlier type had a small plate fitted there which covered a small rubber tube which went up inside the pivot point, I seem to recall it was for helping the lever return to the out position. Not sure why they've fitted a bolt there and added a tab washer, try removing and see what's under it?

Sesman:
Will co.

Nurse Julie:

--- Quote from: Sesman on September 06, 2022, 01:48:43 PM ---Yes, I’m using the pressure switch at the down pipe union. Pardon my ignorance, but what’s the bolt for under the lever pivot?

--- End quote ---
It's an anti rattle aid, a bit of rubber tube that stops the lever rattling.

Oddjob:
Yeah that makes better sense Julie.

Navigation

[0] Message Index

[#] Next page

[*] Previous page