SOHC.co.uk Forums > Project Board
400/4 build. Paused due to other commitments. But starting up again
ComfySofa:
Not been here for a little while. While building has stopped - not for anything bad...just not had the chance to get in the garage coupled with waiting for spares, coating etc etc...
Ill be in the garage on Sunday. Got the exhaust system to fit. Ive continued to get parts in. The Motogadget Munit has arrived along with a load of various coloured wires for building the loom.
That being said i have an electrical related question....as you can see from the previous pics the engine is in....but to that end when i start the wiring i need a good ground - so one thing i "think" ive got to do is to unbolt the engine and sand off where the engine touches the frame so the ground runs through the engine and frame....can anyone advise.?
And, once again, thanks to Brian again for the engine and carb work - without you i would not be where i currently am.
ComfySofa:
A few pics of stuff....everyone likes pics!
Sent from my SM-G988B using Tapatalk
ComfySofa:
Oh. Had some rear spacers machined from stainless to replace the mild steel jobbies...
Sent from my SM-G988B using Tapatalk
ComfySofa:
Another question is the rear shocks. Ive got the original ones which are pitted rusted and generally tatty. I was thinking of going for a set of aftermarket shocks (Niton, ohlins, yss) or something like that - not for any performance reasons but more for the aesthetic....the rear shocks are the main part youre eye is drawn to (in my opinion) - has anyone got any suggestions??
taysidedragon:
A few people have recommended TEC shocks for a good performance at a reasonable price.
The standard spacers on a 400f are 2 different sizes. Yours both look like the long one, the other onecshould be shorter.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version