SOHC.co.uk Forums > CB500/550

Crank not rotating

<< < (2/13) > >>

McCabe-Thiele (Ted):
My thoughts.
1.Is it in neutral.
2.Is the cam chain free.
3.Did you Plastigauge the mains.
4.Are the conrods free.

alexdecker:
Everything is free. I didn’t plastic gauge, as I marked the location of each bearing and put them back in the same place.

murdock:
How big was the hammer you used to remove the rotor? ......
I'm scared of you. ;D
 

Bryanj:
You did put the shells into the cases with cases and back of shells dry didnt you,mixing up shells would not normally lock it up, i have built with all tightest shells before now with no problem.
Primary shaft needs to be fitted and cam chain free but should turn by hand.
You havent tried to miss match cases?

Johnny4428:
Crank seal located correctly?

Navigation

[0] Message Index

[#] Next page

[*] Previous page