SOHC.co.uk Forums > CB350/400
Tool buying Advice requred
Eldrick:
--- Quote from: Nurse Julie on May 14, 2022, 07:32:03 PM ---Don't worry too much about vac sync gauges, you can set the slides very, very, very close by manual bench sync.
--- End quote ---
I may have just done that bit with 3.2mm feeler guage. I also think I can afford that wrench if it is the Britool AVT300A
McCabe-Thiele (Ted):
--- Quote from: Eldrick on May 14, 2022, 09:07:44 PM ---
--- Quote from: Nurse Julie on May 14, 2022, 07:32:03 PM ---Don't worry too much about vac sync gauges, you can set the slides very, very, very close by manual bench sync.
--- End quote ---
I may have just done that bit with 3.2mm feeler guage. I also think I can afford that wrench if it is the Britool AVT300A
--- End quote ---
Not sure that model has a high enough range at 33Nm?
Bryanj:
3.2 is a bit big, better using a 1/16 drill bit shank preferably new so no damage
Rozabikes Tim:
--- Quote from: Nurse Julie on May 14, 2022, 07:32:03 PM ---Get a Britool 3/8 torque wrench if you can. That will cover 99.9% of the torques on your bike. Don't worry too much about vac sync gauges, you can set the slides very, very, very close by manual bench sync.
--- End quote ---
ok so what torque range do we need?
Bryanj:
If you want to torque every thing 8 ftlbs to 50 ftlbs, leave out the alternator, primary gear and clutch nut and 8 ftlbs to 20 ftlbs will do.
Those 3 are normaly done to BT.
Gauges are Sealey VS209 gone up to £150 cheapest on ebay, nearest thing to genuine Honda ive seen anywhere
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version