SOHC.co.uk Forums > CB500/550

Crankcases assembled but can't select gears

<< < (3/7) > >>

ebmbiker:
Makes sense. I'll start dismantling it! Everyday is a school day!

Sesman:
Like this

Sesman:
Is the cam plate correctly assembled. It’s difficult to get wrong as only one locating pin is ‘raised’ relative to the others. If not the drum is in the wrong orientation, which is equally difficult to get wrong! Good luck.

Oddjob:
I'd say you are right Phil, the top roller goes into the indent in the pin plate when it's in neutral, it's so you get a positive selection of neutral when you need it.

ebmbiker:
Cheers guys for the continued advice and wisdom. I need to get an M12 X 1.25 metric fine bolt so I can draw the primary shaft off. My car mechanic mate might have an actual slide hammer.

Navigation

[0] Message Index

[#] Next page

[*] Previous page