SOHC.co.uk Forums > CB500/550

Low speed misfire

(1/2) > >>

peterengland:
Ok CB550 and when I pull away seem to have a misfire, when I'm in 3rd and above there is no problem, sweet as a nut. Used to happen in all gears but have renewed points and timing spot on, filled tank and shot some Redex in so since this it seems to get better every run I have. Is it just the Redex cleaning out the carbs? Obviously trying everything before I have to remove the carbs (46A) cos they are a pain to do, 1/2 hour to remove but 2 hrs to replace the sodding things!

K2-K6:
I always feel it's difficult to decide if reddex has actually done much in what is claimed, but one element this appears to improve is things like the float valves if they are sticking or slightly draggy at all. In other words, more reliable switching of fuel supply and consequently float/fuel level in the bowl.

Certainly it won't do any harm to run a little further and asses to see if you feel improvement is definitely there. Then accept the decision to go into it to more depth if it's not playing ball with you.

The reddex/heat cycle/vibrations may just get them to wake up for you.

McCabe-Thiele (Ted):
I was told by a highly knowledgeable Oil Technology Chemist (Bob Cutler)  that Redex was developed to assist in preventing the build up of carbon deposits in the engine, primarily the valves/cyliner head /piston crown/spark plugs. It does this by raising the burning temperature of fuel  in the combustion chamber preventing the build up of carbon deposits. The same person advised me that 2T mineral oil is almost as effective and cheaper. Clearly adding too much can in fact lead to a build up deposits so dose is critical.

Your engine might misfire under certain load & fueling conditions causing a brief build up of carbon on the plugs - fouling. Adding Redex can prevent that by the higher burn temperature preventing plug fouling. I have found it also cleans injectors on petrol engines and raises compression on older high mileage engines - I ran a Merc W124 series 260E that had 184,000 miles on the clock - it would start almost instantly when I used a small amont of 2T oil in the mix.

Bob Cutler started his career at Lubrizol moving to a number of firms over the decades since we left college together. In his seventies he started his own firm in the very specialized field of oil analysis based near Conwy with his son Adam.
.

https://oilanalysislab.com/lubewear-true-wear-metal-analysis-from-oil-analysis-laboratories/

K2-K6:
Interesting link Ted.

Lubrizol as I understand make many of the addative package element that main stream motor oil manufacturer use to bring bulk base oil to their specification and performance.

McCabe-Thiele (Ted):
I've never understood the technology but Bob worked hard for his previous company who developed special sump plugs for large engines  in shipping fleets as well as aerospace. When analysed the plugs would tell the owner what the wear was in an engine by measuring the metal content in the oil that the plugs absorbed. Comparison with the engine metalurgic components is somehow reflected in the oil via wear.

Navigation

[0] Message Index

[#] Next page