SOHC.co.uk Forums > CB500/550

Rear brake stay arm fitting

<< < (2/5) > >>

Bryanj:
Now you nudged me i think it is plain, spring, nut and split pin(or R clip)

Sesman:
Mmmm. I think it’s rubber, stay, plain washer (slides over shoulder of bolt), nut and pin. I don’t think the manual features a washer,, but I didn’t like the distance from the pin to the nut. So maybe it was a plain washer and spring washer, but I doubt it.

Sesman:
FYI

Sesman:
I think that the objective is to have the brake stay nicely sandwiched between the nut and the rubber washer, with the nut shouldered against the unthreaded part of the plate bolt. In other words the rubber, if of the correct width should sit just slightly higher than the unthreaded part of the bolt so it’s compressed slightly by the stay arm when shouldered a giant the bolt. But that could be complete bo##”s.

Sesman:
Oh dear. CMNSL picture which differs. Washer and spring washer. The rubber bush isn’t shown as it appears elsewhere in the fiche. ::)

Navigation

[0] Message Index

[#] Next page

[*] Previous page