SOHC.co.uk Forums > CB500/550

Tearing bike down

(1/2) > >>

Davelu88:
Hi all
           I have been tearing bike down and am now at the wiring loom then the engine removal , can I remove the engine on my own or is it a 2 person job . I remember doing my 400/4 by lying on side but the 550 is a bit heavier,  thanks in advance Dave

Oddjob:
It can depend if your intention is to dismantle the engine anyway. I find removing all the casings etc head and barrels makes the engine light enough to lift out by yourself. However if the engine is staying intact then lay the frame down, remove all the engine plates etc beforehand and lift the frame away from the engine. A little protection on the floor helps avoid any damage to casings etc.

Davelu88:
I believe the engine  is OK,  so I want to get frame etc powder coated and clean and paint the engine.  Many thanks

Trigger:
It depends on how strong you are  :o Remove the oil filter, sump, strainer , and breather cover makes it easier  ;)

Davelu88:
I will let you know if I put my back out  ;D , also where the rear brake arm goes through the frame is that a sleeve in the frame or not , as if so does it come out before powder coating.  Thx dave

Navigation

[0] Message Index

[#] Next page