SOHC.co.uk Forums > Project Board
CB 500 resurrection
Oddjob:
Never ;D ;D ;D
Oddjob:
Oh and when fitting the clutch casing, don't forget there's a washer that goes onto the kickstart shaft to go between the circlip and the casing.
gary123:
--- Quote from: McCabe-Thiele (Ted) on September 08, 2022, 11:40:48 AM ---With so many mixed parts your build must be like mixing up two jigsaw puzzles then trying to complete one without a picture to help.
Amazing progress so far - I would be having sleepless nights plus getting up at 2.00 am to check something.
Then when you think you have done it Ken points out something you have missed - beware - Ken can be the joker in the pack sometimes.
--- End quote ---
Yeah, its the mix of parts that is causing a few issues, and TBF dont think I could have got this far without the forum. and of course if it goes bang on start up it will be you lots fault :) :) :) :) :) :)
gary123:
--- Quote from: Oddjob on September 08, 2022, 12:59:10 PM ---Oh and when fitting the clutch casing, don't forget there's a washer that goes onto the kickstart shaft to go between the circlip and the casing.
--- End quote ---
Yep spotted that, finding it is a different matter :)
gary123:
Some progress has been made but now I cant find/don't have the two locating dowels that slip over the studs.
Re the washers that go under the stud nuts, will any washer of the correct diameter do or must they be the specific ones, dont have them either? [ Guests cannot view attachments ]
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version