SOHC.co.uk Forums > Project Board
CB 500 resurrection
Nurse Julie:
--- Quote from: Bryanj on July 22, 2022, 09:26:55 PM ---Better of driving to you then Julie! I looked up Moulton and it said Wiltshire.
Still trying to assemble the 400 jigsaw, its a bit of a bugger when you didnt take it apart and the last one i did was, shall we say several, years ago.
Dont think 3 hours from dynamite to mated cases is too bad!
--- End quote ---
Not too bad at all Bryan.
gary123:
--- Quote from: Bryanj on July 22, 2022, 08:45:05 PM ---Where exactly are you? If its Wiltshire you are not far from Gloucester so i could help if you wish
--- End quote ---
Yes, as Julie says Im a fair way from you, but thanks anyway.
Im hoping I can get the engine done myself but Ill no doubt reach out at for help at some point.
gary123:
Some pics of work so far. [ Guests cannot view attachments ] [ Guests cannot view attachments ] [ Guests cannot view attachments ] [ Guests cannot view attachments ] [ Guests cannot view attachments ]
gary123:
Im sorting out the wiring at the moment. Its going ok, I have a nos loom and the switches are new but may not be correct.
Biggest issue is the length of wires on the switches. where the eck does it all go.
mickwinf:
wiring does vary from 500 to 550 and between different models. Original 500 the wires from the switches run inside the handlebars then meet the main loom in the headlight bucket. the 550 f1 and f2 had a juntion box under the tank so wires from switches are much longer, maybe you have those? also 550k3 is different again, external wires with block connectors, and also slight differences for different countries.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version