SOHC.co.uk Forums > Project Board
CB 500 resurrection
gary123:
--- Quote from: Nurse Julie on October 11, 2022, 08:43:43 PM ---Have you got the alternator and stator in the right way round Gary?. There should be clearance if they are fitted correctly. And is the flywheel correctly torqued?
--- End quote ---
Pretty sure I have Julie, but Ill go over it in the morning. Yes torqued up to spec.
Johnny4428:
Not a lot of clearance when set right. There is a couple of dowels to align casing. I forgot mine on the 550 start up and I had contact. Was quickly remedied with dowels in place.
Bryanj:
Check the rotor is spinning true, i have had a bent crank end before
gary123:
--- Quote from: Johnny4428 on October 11, 2022, 09:23:30 PM ---Not a lot of clearance when set right. There is a couple of dowels to align casing. I forgot mine on the 550 start up and I had contact. Was quickly remedied with dowels in place.
--- End quote ---
Good point, Ill check.
gary123:
--- Quote from: Bryanj on October 11, 2022, 09:43:53 PM ---Check the rotor is spinning true, i have had a bent crank end before
--- End quote ---
OK, Ill spin it on the starter and see if it "wobbles". Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version