SOHC.co.uk Forums > Project Board
CB 500 resurrection
Laverdaroo:
aaaahhh, the familiar Anglo Saxon announcement at times like this ;D ;D ;D ;D
Alwaysappears to help!......That or get you a telling offbecausefolk can hear ;D ;D ;D ;D
Bryanj:
Just like me walking into the garage door when getting bits for those 400 carbs i di, got a delicate hole in my forehead and my wife said "did you swear"
Laverdaroo:
Yeah, laughing all the skin off my forehead dear, of course I didnt swear!! ;D ;D ;D
paul G:
--- Quote from: gary123 on October 12, 2022, 10:22:55 AM ---
--- Quote from: Trigger on October 11, 2022, 11:26:10 PM ---
--- Quote from: gary123 on October 11, 2022, 10:24:41 PM ---
--- Quote from: Bryanj on October 11, 2022, 09:43:53 PM ---Check the rotor is spinning true, i have had a bent crank end before
--- End quote ---
OK, Ill spin it on the starter and see if it "wobbles". Thanks
--- End quote ---
Do Not start it without the cover on as, the oil pressure will push the bung out and you will have all the oil on the floor ;)
--- End quote ---
Cheers Trig, thats good advice, and probably what I would have done.
--- End quote ---
I did on the 400/4 and trust me it takes a while to clear it up ;) >:(
gary123:
I can only imagine. Im a bit ocd about my garage, wife wishes it applied to the kitchen.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version