SOHC.co.uk Forums > CB350/400

Main jet - which way up?

(1/2) > >>

oldchuffer:
Putting new jets in my carbs and i notice the ends are slightly different, one end seems to have a deeper drilling than the other, does it matter which way round they go?  Which end should go in the carb first? [ Guests cannot view attachments ] [ Guests cannot view attachments ]

Pic a shows the deeper end, Pic b not so deep.

McCabe-Thiele (Ted):
Can you not check them against the old ones?

There might be markings where the O ring was.

Johnny4428:
Couldn’t tell you the correct way up but with the needle tapered it will make a difference which way up. IMO

McCabe-Thiele (Ted):
I've just checked my part dismantled spare set of 400 carbs.

The drilling on the top end is shallower than on the bottom.

The shallower side is the upper part next to the "O" ring from what I can see.

It looks to me that as the needle does not go down that far that its just the hole diameter metering the fuel flow. I am thinking the mixture is controlled by the emulsion tube & the needle.

Your second photo shows the top of the item.

Bryanj:
Look at the originals, numbers and emblems are visible when fitted.
Better cleaning the original than fitting pattern, goes for all the brass

Navigation

[0] Message Index

[#] Next page