SOHC.co.uk Forums > Project Board
Teds new project a CB500 K1 mostly version 0.5 circa 1972.
Oddjob:
Nothing on the upper rear bolt except the spacer fitted on the left hand side between the crankcase and the frame. The hanger goes on the inside of the frame.
50357-323-010 is fitted on the left hand side of the lower bolt, again between the crankcase and the frame. Nothing else Ted, if there was you'd see it on the parts book diagrams.
McCabe-Thiele (Ted):
Ken this is the parts manual showing what I am on about it's the lower rear long engine mounting bolt. Item 9.
.Screenshot 2023-07-04 190020 by Macabe Thiele, on Flickr
Oddjob:
Bottom bolt Ted, goes between the crankcase and that frame lug sticking off the frame. It's quite thick TBH, about 10-12 thick IIRC. Max does them in stainless.
McCabe-Thiele (Ted):
In that case I have one methinks.
Bryanj:
You should have, i put one in there, may even have been a nos one
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version