SOHC.co.uk Forums > Project Board
1977 CB750F2 Restoration
Oddjob:
Think someone drilled the holes to maybe fit some indicators as the stems are not easy to find.
Spitfire:
Just had a look at the ones that I have and I think that you are correct, I measured one and it is 81/4" in old money or 21cm and the hole does not look like Honda did it, it was probably me (vandal) for some obscure reason, probably to fit reflectors. Will either use them or some headlamp brackets that I have or look for replacements
Cheers
Dennis
Spitfire:
In other news my new dampers have arrived I looked for the TEC ones as recommended in another thread on this site but they are not in stock, and I could not find any Hagons either so these will have to do.
These were the ones that I was going to use but the red phase has gone
Cheers
Dennis
Laverdaroo:
The very same ones i got for the 550. They should be spot on. I was after the TEC ones also but theres' none anywhere, even second hand sadly. The piggy back is a great look but these will be better than you thnk.
Oddjob:
I have a pair of those Marzocchi Strada rear dampers, they are completely apart at the moment and I have new seals, rods etc from Italy. I’m going with black body and chrome springs
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version