SOHC.co.uk Forums > CB350/400
400/4 Taiwan jet sets
Oddjob:
Look closely at number 4 and you can see the circlip has folded, the tangs are out of shape, add in that the needle has a ring around it makes me believe it got stuck in the bore somehow, it was then forced down by the pull cable as the engine was revving and it couldn't be stopped, this bent the tangs on the circlip and pushed the circlip down the needle.
McCabe-Thiele (Ted):
Well spotted Ken.
FWIW my bike came with a set of Keyster kits KH-0147A (1610-377-004/044) - I fitted them - they were fine.
I have of course kept all the old parts just in case there is a problem in the future,
Johnny4428:
That must have made No4 run rich! I raised the needles in my carbs just by one groove, it started brilliant, but reeked like an old steamer.🤣
Cappodimonte:
Does anyone know where I can get the small connector pipes which I think are 3mm internal diameter which fit between the carburettors for balancing purposes, knowing they’ll need to be ethanol resistant. Around here they look at you as though you have three heads.and six fingers on each hand.
Laverdaroo:
Try a lawnmower shop that supplies Styhl stuff, they usually have it in stock. Some brewing shops also stock it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version