SOHC.co.uk Forums > CB350/400

I think the slides are in the wrong bodies

<< < (4/11) > >>

Sesman:
Is it just two or all four?

Sesman:
It’s hard to see on the photos, but if that’s 2 photos of cylinder 4, it looks to be correct. Eg cut out is on the inlet side?

Sesman:
The carbs are obviously off. Those look very high to me if the actuator is in its static position!

McCabe-Thiele (Ted):
When I set my lifter heights I used the shank of a 3/16" drill bit using this video as a guide.

https://www.youtube.com/watch?v=JFTOfYl5BSc

Sesman:
3/16” is good for the intake side, but I’d use 1/16” on the engine side.

Navigation

[0] Message Index

[#] Next page

[*] Previous page