SOHC.co.uk Forums > CB500/550
Has anyone used these coils?
Brocky2:
I measured the primary resistance at 4.7 ohms.
I can’t work out how to share the actual link but copy and paste this into eBay and you’ll get it.
Ignition Coil x2 Honda CB400 CB500 CB550 CB750 GL1000 - 90mm 12V Points
deltarider:
--- Quote from: McCabe-Thiele (Ted) on April 23, 2024, 12:54:09 PM ---[...]
Is the primary resistance quoted?
A link to the actual item would help.
--- End quote ---
This ^ and is it a known brand? Advice in general: If no brand and made in China, abstain from ordering.
McCabe-Thiele (Ted):
Looks like these then. branded as SMP made for the seller in Taiwan?
.https://www.ebay.co.uk/sch/i.html?_from=R40&_nkw=Ignition+Coil+x2+Honda+CB400+CB500+CB550+CB750+GL1000+-+90mm+12V+Points&_sacat=0
beardylondon:
Received these, both appear genuine and boxes too, both with unpainted NGK logo
deltarider:
They are the same I have. Tip: use a little vaseline, silicone oil or similar inside the upper sealing rubber before you screw the HT wire on. That rubber seal is a bit tight and could therefore resist slightly and give you the feeling you are already there, when in fact you're not. Then you would have a bad connection.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version