SOHC.co.uk Forums > CB500/550

fuel pipe check ..... 950013500160M

<< < (6/6)

Sesman:
Standard torque settings really depends on thread type and bolt type. The higher values correspond with high tensile and fine threads. Go by the  manual, assuming you have the correct fixings.

Oddjob:
I always used my thumb as a guide, I'd put my thumb on the side of the head of the ratchet and when it felt tight enough I'd stop. I checked it once to see how much I was putting on there and it was perfect so I always do that now.

Seabeowner:

--- Quote from: Oddjob on October 16, 2022, 12:09:37 AM ---Modern manuals say 6.5ftlbs for a 6mm screw and 7ftlbs for a flanged 6mm bolt.

--- End quote ---
1974 manual calls for 6mm hex bolts 5.8-8.7 lbs ft
Clutch spring bolts are especially picked out as higher, up to 10.1.
Maybe one of the many mistakes and maybe they had a lot snapped.

Sesman:
That would be for for a ‘fine thread’, which they are….

Navigation

[0] Message Index

[*] Previous page