SOHC.co.uk Forums > CB500/550

Cb550 k3 primary chain

<< < (7/9) > >>

Oddjob:

--- Quote from: Sesman on November 03, 2022, 04:06:33 PM ---I’ve just seen a squirrel…..🫣

--- End quote ---

WTF does that mean  ;D ;D ;D ;D ;D

SteveD CB500K0:
I was a moderator on .net for many years.

This is a walk in the park compared to some of the gun threads we had to deal with.

Having said that, just agree to disagree guys.

Please.


Sent from my iPhone using Tapatalk

fourfive:
I've decided to strip the engine and replace the chain. Trying to get the rotor off the crankshaft I screwed the removal tool into the rotor, First tried with a crack bar but no joy. Then I used an impact gun, still no joy and the threads have stripped on the rotor.
Will I damage anything using heat?
Any other suggestions welcome.
Thanks Ian

Oddjob:
You stripped the threads, Jesús never heard of it doing that before. Try some heat, won't hurt. You need to get it off to replace the oil seal behind it.

Not sure where in the UK you are but probably a member close by with a spare rotor lying around. I've got quite a few, some are rusty but would clean up ok.

fourfive:
I'm near Sheffield, couldn't believe it when the threads came out. Blow torch out in the morning.

Navigation

[0] Message Index

[#] Next page

[*] Previous page