SOHC.co.uk Forums > CB500/550

How to assemble rear dampers after dismantling & cleaning ?

<< < (2/3) > >>

Bryanj:
The car ones are too big for the honda dampers Ted

paul G:
Finished item  :)

AshimotoK0:
This is my cheap and cheerful one made literally from scrap lying around .. about 5 years ago. (no  machining whatsoever involved...I didn't even chop the M8 stud with a hacksaw) Must have done about 30 sets of shocks successfully with it . OK ..should have used M10 stud not M8 .. answer : didn't have any to hand and I am a Yorkshireman. Missing is a bit of ally extrusion that stabilises the bottom fork to stop everything slipping out. Mock it all you like but it does the job  ;D

Laverdaroo:
Looks perfect to me Ash, and i fit works....it works! ;)


What is the name of that flux you send me a while ago when I was doing those cois, its great stuff? Nearly used it all up and would like some more of that it's probably the easiest to use flux I've had in the workshop. Would you know what make it is or should I assume it's RS? ;) :)

Hope all's good at your end Ash,best regards n all that.........

AshimotoK0:

--- Quote from: Laverdaroo on November 17, 2022, 12:12:38 PM ---Looks perfect to me Ash, and i fit works....it works! ;)


What is the name of that flux you send me a while ago when I was doing those cois, its great stuff? Nearly used it all up and would like some more of that it's probably the easiest to use flux I've had in the workshop. Would you know what make it is or should I assume it's RS? ;) :)

Hope all's good at your end Ash,best regards n all that.........

--- End quote ---

Yea, all is good thanks ...Was it the brown paste type flux  or the golden liquid stuff Roo?

Navigation

[0] Message Index

[#] Next page

[*] Previous page