SOHC.co.uk Forums > SOHC Singles & Twins

CM125 wiring diagram

<< < (3/4) > >>

Tomb:
Brilliant, thanks fellas!!

All info is helpful. Andy, the images are as you say, a bit too blurry to make out on here, if you could email the images that would be great. I’ll PM you my email address   

I should take some photos as we all love a photo of a bike build don’t we 😊

andy120t:
Tom,
Email sent just now so let me know if they are readable!

Piccie would be great…I need to dig out one of mine too. BND714Y if I remember correctly.

Tomb:
Absolutely brilliant images Andy. Many many thanks

Tomb:
I don’t know what I’m doing wrong but the photos will not load

Anyway, a really successful day, most of the wiring done thanks to great help here, thanks chaps. Really needed that diagram to help sort out the clutch switch /neutral light and diode wiring for the starter solenoid. All lights working apart from back light which is yet to go on with rear mudguard, indicators working, we have a spark at the plugs.

The coil is after market fitted by PO and the spark is weak with the correct spec’ resistor plugs, tried an old none resistor plug of mine and get a much better spark so not sure what’s going on. I may simply use none resistor plugs if that works ok, any thoughts on that welcome.

Tomb:
Photos, no idea why they are flipped on their sides.
[ Guests cannot view attachments ]

[ Guests cannot view attachments ]

And had a play with this little fella on Saturday
[ Guests cannot view attachments ]

Navigation

[0] Message Index

[#] Next page

[*] Previous page