SOHC.co.uk Forums > CB350/400

HELP! Rear wheel damper/bush removal

<< < (3/3)

Laverdaroo:
winning! ;D.............

Theres a few you tube videos on it,might be 'spanner rash' I'll have a look in a bit and send it on to you.

philward:
It was me! I didn't know that the 400 has rubber/steel collered cush drive bushes - thought the cush drive rubbers where the same as the bigger Fours - all rubber, hence I thought you were describing removing the shock bottom mounts - apologises for confusing the issue

SeanFD:
I used lots of heat, a cold chisel and a 2lb hammer. It took ages and the inner surface was well scratched at the end, but this was sorted out with a Dremel.

A mate showed me a good way to get the lower shock bushes out, using a couple of sockets and a vice. Posted for anyone else who might find this a novel approach.

Navigation

[0] Message Index

[*] Previous page