SOHC.co.uk Forums > CB500/550

Frost Strip

<< < (2/2)

paul G:

--- Quote from: Skoti on December 12, 2022, 07:29:03 PM ---Just wondering,

With MEK do you have to put screws or some sharp stuff into the tank and shake it around a bit, or does MEK on it's own totally strip and dissolve the old tank liner?

--- End quote ---
I didn't but don't think it would hurt anything.
Just don't breath the stuff in :o

AshimotoK0:
What I did with a 500 tank with a  liner (tank was off a USA import) was to chuck a kilo of caustic soda into the tank ..equal amounts on both sides. Bung a piece of 1/2" hose about 1.5 meters in length into the tank filler neck, with a funnel on the end and then poured a kettle full of boiling water into the tank via the hose at a distance well back from the tank. After the mayhem had subsided this is what came out.

Not the most PC or HSE friendly method and to be done with great caution, I may add, as a disclaimer. Exotherm man  ;D

[ Guests cannot view attachments ]

Orcade-Ian:
That's impressive Ash!
What did you do to seal the tank afterwards?   Ash's Special Brew, Proprietary kit or cut and weld patches?

Ian

AshimotoK0:

--- Quote from: Orcade-Ian on December 13, 2022, 08:42:43 AM ---That's impressive Ash!
What did you do to seal the tank afterwards?   Ash's Special Brew, Proprietary kit or cut and weld patches?

Ian

--- End quote ---

I basically did it as an 'experiment' as I got another tank that was in lovely condition with my bike and Menno painted it for me.

I have used that method on a few tanks that were full of stale petrol/varnish though and it was great for removing that too.

Navigation

[0] Message Index

[*] Previous page