SOHC.co.uk Forums > CB350/400
Carb rebuild
Multiman:
Hi all
Here's wishing you all a very happy New Year.
Laverdaroo has done a spectacular job on refurbing my carbs and so it's on to refitting. Thanks again Roo!
I had already bought some new throttle cables from Wemoto and fitted them beforehand.
Unfortunately when I split the right hand switch gear to do the job, I discovered a red and yellow wire in mid air.
After checking the wiring diagram, I disassembled the lower starter motor switch further and soldered the red and yellow back onto the small contact mounted on the tiny bit of U shaped insulation board.
Put every thing back together (oh to be an octopus) and whilst the starter works it has no "feel" and I'm worried might vibrate into contact whilst the engine is running.
So to cut a very long story short I've lost the spring that must live in there behind the starter button.
I've spent and hour on my hands and knees but can't find it, if it ever existed.
Two questions,
1. anyone got a spare starter button spring, or got dimensions of one?
2. Could someone describe how the parts go together as there is no exploded diagram I can find in manual or parts book and I'd like to be sure.
Many thanks
Cheers
Tim
Bryanj:
If the 400 grounds to the bars go to the 500K0 parts fiche on cmsnl and there is a part number for both spring and button
500 spring part number is 35318259000
Multiman:
Ah thats good info.
I shall take a look, thanks.
Tim
McCabe-Thiele (Ted):
Tim I have a complete switch that has had the wiring cut off plus a section has been cut off the lower case to allow the wiring to be external on bars. The starter action seems good. If you PM your e-mail address the unit is all yours f.o.c. just postage cost.
Cheers Ted
Multiman:
Ted thanks incredibly kind.
I'll pm you
Best
Tim
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version