SOHC.co.uk Forums > CB350/400

Fitting a new wiring loom

<< < (3/5) > >>

Multiman:
PS And if Ido need to fit this where on the loom/wiring are the connectors?

Many thanks in advance.

Tim

McCabe-Thiele (Ted):
Difficult to diagnose elctrical issues remotely but............. did the lights all work as they should  before you fitted the new loom thus eliminating a switch problem?
Have you changed the fuse box - I would ould check the fuse box & fuses for continuity.

I fitted the DS cheaper fuse box & had to re=solder a dry joint on the back.

Multiman:
Hi Ted

yes everything worked ok before fitting the loom.

I've checked thew fuse box and all three fuses are ok and get power, its not been changed.

McCabe-Thiele (Ted):
Have you checked the terminals at the back of the fuse box you can have a live feed & on the output side but are the wires at the back of the box where they are soldered on making a connection? I would then check the feed from the fuse box to the switch following the colours on the circuit diagram along the loom.

Multiman:
Hi Ted
I haven't changed the fusebox and from what I have tested it's getting power and passing it on correctly the query I have is about should I make up the connection I pointed out in the wiring diagram.
I think I'll call it a day for now and resume in the morning after sleeping on it.
Thanks for your input as always
Cheers
Tim

Navigation

[0] Message Index

[#] Next page

[*] Previous page