SOHC.co.uk Forums > CB500/550
Clutch push rod question ?
K2-K6:
To conserve the corrosion part, you could stand that end in rust converter fluid to stabilise, then just coat it in marine grease when installed to stop further deterioration.
McCabe-Thiele (Ted):
You have read my mind I've already dipped it in Evaporust overnight then Blued the end for protection.
Seabeowner:
DSS have lots of matching rusty ones:
https://www.davidsilverspares.co.uk/CB500K1-FOUR-1972/part_334325/
Laverdaroo:
You should be able to get it hard chromed Ted, I had mine done as it was as skanky as that one you're holding. Came out great and was about 35 quid I think.
Someone on here had some carb connecting bars done that looked ace, might have been Ken but have a look Iit might be on his back after 30 years thread I think........
Bryanj:
Difficult to chrome as the ends are steel but the middle ally as i remember, Honda did do a complete steel one but the clutch action was slow
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version