SOHC.co.uk Forums > CB750
Carbs Install
Martin6:
Julie,
Bike is UK. My bars are UK. I fitted the new cables yesterday. They are also UK and seem fine.
You are right, I'm not sure about my switchgear. I may be confused... If a UK K6 has the sprung screw under the bottom half of the switchgear (which screws up into the throttle tube housing), then it might be right. I had read that this was discontinued on K6s?
My [current ::) ] problem seems to be the wires for the starter button not having enough space to get from the switch to inside the bars. The red/yellow is the main problem, although the black is also tight. I suppose, possibly wrong switch for the bar holes, but I'm suspecting it will work, if the soldered connection is right.
I'd like to somehow check that the red/yellow is soldered correctly on to my switch.
Nurse Julie:
We have our UK K6 on the ramp for it's yearly service. The UK K6 has the sprung screw fitted to the switch.
I have taken some pictures of the switch and a switch that has been taken apart so, you can see how the Yellow/Red and the black are connected .
Johnny4428:
Good job Julie. Looks like could do with a bit of a clean.😜
Martin6:
Darned sight cleaner than mine!
Thank you very much Julie. I think that's my switch and I think the joints are currently different. Will double check this morning and crack on.
Thank you for your help. Really brilliant. :)
Martin6:
Interesting. My red/yellow is where your black is and vice versa. Doesn't matter, but shows mine has probably been repaired before. Except, where your black goes in from the underside, mine (R/Y) is soldered to the top. This is causing my problem. Just not enough space to route between the bars and the switch. So, if there's enough wire, I will change that. Fingers 🤞.
Thanks again.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version