SOHC.co.uk Forums > CB500/550

500 wiring loom frame fitting pics.

(1/3) > >>

McCabe-Thiele (Ted):
When I was fitting the  new loom to my 400 there were some lovely photos of how the wiring & cables flowed around the frame.
Are there any similar sketches for the 500 - I've looked in Ash's dropbox & the manuals without success?
My loom looks pretty good I just need to tidy up the outer bindings here & there etc.

Photo below shows where my loom was routed before strip down so need to tidy it all up.

.500 loom routes by Macabe Thiele, on Flickr

Johnny4428:
Nothing to do with me Ted, but a loom that age I would completely strip off outer binding to visually inspect all wires. Did that with the 550 and ended up replacing a couple of wires.

McCabe-Thiele (Ted):

--- Quote from: Johnny4428 on April 28, 2023, 05:34:01 PM ---Nothing to do with me Ted, but a loom that age I would completely strip off outer binding to visually inspect all wires. Did that with the 550 and ended up replacing a couple of wires.

--- End quote ---

Sound logic - there are not expensive  to replace on the grand  scale of rebuilds.

Deano400:
Ted,

Go to this site and download the CB500-550-K-Shop-Manual. Has a couple of diagrams from page 146. Might be helpful.

https://www.honda4fun.com/modelli/cb500

McCabe-Thiele (Ted):

--- Quote from: Deano400 on April 28, 2023, 05:52:56 PM ---Ted,

Go to this site and download the CB500-550-K-Shop-Manual. Has a couple of diagrams from page 146. Might be helpful.

https://www.honda4fun.com/modelli/cb500

--- End quote ---

Thanks for the page number Deano best pic I've seen so far.

Navigation

[0] Message Index

[#] Next page